montanazuloo.blogg.se - Antilaser priority net radar filter

Antilaser priority net radar filter how to#
Antilaser priority net radar filter install#
Antilaser priority net radar filter update#
Antilaser priority net radar filter software#

My new Avatar represents Valentine 1 customer Service reps: How may I help you? NOTE: The audible voice you hear from the system is part of the ALP HiFi Module (sold separately) without this accessory, you would simply hear some beeps. Credits: Video by Vortex (forum Moderator) To be on the safe side, only have the Settings file on your USB drive when you do this (ie do not have the Control Box or Control Set files on the USB drive).

Antilaser priority net radar filter install#

NOTE: If you add new sensors to your system, you will need to RESET your ALP (Step #4) again and install just the Settings file. I.Ěllow 1 minute to pass after the ALP restarts before removing your USB drive.įINISHED – Your ALP is now updated, configured to your settings, and ready for the road. When the ALP restarts, it will automatically upload your Settings file. G.ĚLP will automatically begin updating the Control Set firmware and restart when it finishes. The ALP will automatically restart.Į.Ěfter the ALP restarts, turn it OFF (hold PWR button until you see the RED LED blink rapidly then release) NOTE: If there is an issue as described, you will be alerted with a CONSTANT RED LED and SHORT BEEPS for 5 seconds.Ī.Ĝopy the three files listed above onto your USB drive.Ĭ.Ĝonnect the USB drive to the USB socket on your ALP Control Box or your USB Extension Cable (if iinstalled)ĭ.ĚLP will automatically begin updating the Control Box firmware. This allows the ALP to do a Self-Check every time you turn it ON and alert you if a sensor is bad or disconnected. The configuration file will be called “setup.alp”Įnsure your ALP memorizes the position and status of your sensors prior by performing a RESET. If you prefer to control this timeframe, set the option to UNLIMITED.” On this setting you will have to CLICK the PWR button once to stop the ALP from continuously countering the threat.Į.ĜLICK the blue “Save and download” button at the bottom of the page and specify the “ALP” folder where you have saved the Control Box and Control Set files. The Laser Interference Defense (LID) Time option is set at “4.” This is a typical automated JTK timer that will prevent your ALP from countering threats after 4 seconds from the time it encounters a threat.

Antilaser priority net radar filter update#

NOTE: In the future, when you want to change a simple setting like Dark Mode, or if you get a GPS receiver and need to enable that setting, you can simply upload the file you are about to configure, and simply update those new settings without having to recreate a whole new file.Ĭ.Ět the bottom you will see “Advanced Options” – CLICK PDC & LIDĭ. On the left side of the page, select your region. Since AntiLaser Priority frequently updates its firmware to combat new LIDAR guns, more than likely, the firmware currently installed on your Control Box is not recent.ī.

These steps have been approved by the manufacturer. For Windows, click here.įollow the steps below in this order.

To format a USB drive on a Mac click here for instructions.

If you choose another USB drive, ensure your USB drive is formatted to MS-DOS (FAT). This drive comes pre-formatted in MS-DOS (FAT32).

Antilaser priority net radar filter software#

If you bought the recommended USB drive noted above, you simply just need to remove whatever proprietary software is on the USB drive that is preinstalled.

a quality USB drive (recommend a 4GB USB SanDisk Cruzer Fit)

Antilaser priority net radar filter how to#

Situation: You just bought an AntiLaser Priority (ALP) system, installed it, and now are wondering how to set it and start it up.